| Accessories |
 |
We will MEET OR BEAT any other advertised, authorized dealer/distributor prices. GUARANTEED!
|
| |
| Extended Antenna Kit |

|
- For use with monopole Monitors only
- 35 ft coax cable – one end attaches to Monitor and
other end attaches to 7.5 inch whip antenna (included)
Note: Can be returned for a full refund if reception is adequate without it!
|
 |
|
|
|
 |
| Echo Repeater |

|
An alternate to the "Extended Antenna Kit" for improved Monitor receptions by amplifying and transmitting Sensor signals via RF to the Monitor.
Use anywhere there is 12v access, i.e. in the motor home rear bedroom, 5th Wheel or towed vehicle.
Includes 12v power cord, Telescoping dipole antenna, and Velcro mounting strips.
- Telescoping dipole antenna included
- Velcro strips for mounting included
Note: Can be returned for a full refund if reception is adequate without it! |
 |
|
 |
 |
|
| Stripped End Power Cord |
 |

|
|
Hard Wire Cord: 8ft power cord that can be hard-wired to the vehicle, replacing the standard cigarette lighter accessory power cord. This cord allows the standard lighter plug cord to be stored and/or used with other vehicles.
|
 |
|
|
 |
| Standard 12 Volt
Power Cord |
 |

|
|
Supplied as standard, but can be ordered as an extra/replacement Power Cord with fused cigarette lighter receptacle plug. Order this item only if you need a second, or replacement cord.
- Connects Monitor to 12-volt cigarette receptacle power outlet
- 8 ft cord
|
|
|
|
| |
| AC/DC Wall Plug-in Kit |
 |

|
|
Converts 110-volt AC to 12-volt DC
- Kit includes power cord and AC/DC converter
- Power cord connects converter to all Monitors and repeater
- Converter plugs into standard 110 outlet
- For use in vehicles that do not have readily available 12-volt power source
- 8 ft cord
- Not for use with other devices
|
|
|
| |
| 24/12 Volt Fixed End Power Cord |
 |

|
|
- Connects Monitor to 24-volt power outlet
- Converts power from 24-volt to 12-volt
- 8 ft cord
|
|
|
|
 |
| RS232 Fixed End Power Cord |
 |

|
|
- Connects to 12-volt power outlet
- Includes RS232 data downloading capability
- 8 ft cord
|
|
|
|
 |
| Molex Power Cord |

|
- Jacketed, 5-wire, 10' power cord with MOLEX connector
- For use with Intelligent Repeaters and BRIDGES
- Opened ended for connection to tractor/trailer wiring network
- Supports Open Collector function.
- 10 ft cord
|
 |
|
|
|
| Visor Clip/Suction Cups |
 |
| |
|
Optional Monitor mounting by use of suction cups or by removing suction cups and attaching to visor.
- 2 clips per set
- Fits onto Monitor from top or bottom for installation onto visor or window.
|
 |
|
|
 |
| Schrader Mast Air Inflator |

|
Very accurate, high quality, factory calibrated inflator (comes with custom test performance curve).
Easy to use; greatly shortens the time required to check and correct tire pressures. |
 |
|
|
 |
|
 |
| Sensor Lock Kit |
 |
|
|
Locks your tire Sensor in place. Kit includes (10) Jam Nuts and (1) Custom Wrench. Lock nuts are not required to secure Sensors on valve stems. They do, however, minimize possibility of the Sensors being stolen.
Must have minimum of 5/16" thread on valve stem. |
 |
|
|
 |
| Dash Top Monitor Mounting Bracket |
 |
 |
|
Bracket mounts on dash area via Velcro (no screws); Monitor attaches to bracket via Velcro for upright position. (Does not include Monitor)
- 2 3/4"W x 2 1/4"D x 1 1/2"H
- Velcro included
|
|
 |
|
|
 |
| Extra
3 1/2" Monitor Antenna |
 |

|
|
Extra 3 1/2" Monopole Monitor Antenna. Note: One 3 1/"2 antenna is provided with each Monitor. Order this item only if you want an extra antenna or as a replacement. |
 |
  |
|
|
 |
| |
| 7" Monitor Antenna |
 |

|
|
Order this 7" Monopole Monitor Antenna if you have the Extended Antenna Kit and require a replacement antenna. |
 |
|
|
Optional RAM Mounts
(for Mounting Monitors)
RAM Mount |
 |
| |
|
- Ram Mount with 2.5" arm and 2 knuckle end plates.
- Allows for direct mounting to vehicle
- Screws allow adjustment of mount at both top and bottom
- Total length and weight: 4" and 6.6 oz.
(Stem is 2.5" with weight of 2.8 oz. Round plates with knuckle ball adds 1.75" to top and bottom) |
 |
|
|
 |
| RAM Mount Suction Cup Attachment |
 |
| |
|
- Suction cup attachment attaches to windows, metal dashes
(non-porous surfaces)
- Power suction lever insures secure fastening
- Total length and weight: 3.6 oz and 3.25"
|
 |
|
|
 |
| Ram Mount/Suction Cup Combo |
 |
| |
|
- Ram Mount and Suction Cup Combination
- Comes with suction cup attached at one end\and a regular round mount plate on the other.
|
 |
|
|
 |
| RAM Mount Mounting Pad |
 |
| |
|
- 2.43" Diameter double stick mounting pad
- Will stick to all non-porous surfaces
|
 |
|